Since the early days of Michael Faraday, man in his attempt to harness Nature has always wound his coils and solenoids in more or less the same way. Winding copper wire in a spiral fashion around an iron core. This technique has proved very useful in many of man's activities, albeit performed in a very inefficient manner.
Both WR and Tesla have advocated that electric current does not flow IN a wire, rather it flows around a wire, a skin effect. MSS continues to describe the current as flowing in a wire contrary to the teachings of these great minds.
MSS has no understanding of the importance of 'dividing gravity', and has even less understanding of the existence and function
of E/W poles.
Some of the issues with fig : 1
- the copper coils are wound with uniform diameter, Nature does not use this technique
- multiplication of potential is achieved but the multiplication is 1 (x 1)
- no allowance for division of gravity
- coils design fights Nature. A 100% E-field is divided into a 50% E-field and 50% B-field (wasted as magnetic field)
- a STATIC division is achieved, but a dynamic division is required
- designers are totally confused over whether to use CW/ACW windings
- copper wire wrapped around iron cores in a N/S direction is the WRONG thing to do
Some of the issues with fig : 2
- all of Nature's bodies spin/rotate/revolve or turn on their equatorial rims. The N/S axis is the axle of rotation
- all of man's electrical devices rotate the armature 90° out of phase with Nature. Man rotates his devices on the E/W axis
- the importance of two foci over a single focal point is not recognised. The field must wobble. This is why Tesla's ac is preferred
WR teaches that the only motion in the universe is that contained within electrical loops of force. That motion is either contracting sphincter style in a centripetal manner to close the central hole, or expanding in a centrifugal manner to open that central hole. The concentrative effort of Mind controls that motion.
TIP: Page 131 of Atomic Suicide
When 100 ft of wire is looped into one large circle and a current passed through it little heat/density will be detected at the center of that large loop. When the same 100 ft is made into 50 loops (smaller diameter) then great heat/density will be evident along the common central shaft.
The diameter of the wire loops determines the measurable activity at the center of the wire loop. Large diameter cathodes will thus appear cold, and nebulous while tightly wound anodes will manifest great heat and density.
Spinning loops of force run 90° to the N/S axis.
|
(fig : 3)
Fig : 3 indicates the circulating loop of force which circulates about a shaft/axle of Stillness. This axle of Stillness IS MIND itself, and the rotating loops are the electrical current manifestation within the physical universe which indicate that Mind is actively Thinking.
Mind manifests within the physical universe as circulating Loops of Electrical Force.
We know we can produce circulating electric loops of force about a current carrying wire !!
These loops of force manifest at 90° to the N/S axis !!!
These loops of force are the same loops as those utilised by Mind when Thinking.
This is after all an ELECTRIC universe !
The entire physical universe is made from spinning loops of force as indicated in fig : 3.
That's it, there is no other motion.
These loops have a critical central hole diameter.
Loops in motion are either closing their central hole, or opening the hole up.
That's it, there is no other motion.
The effect of this simple motion is extremely complex, not helped by our sensing apparatus !!
|
(fig : 4)
Notice, the loops are perpendicular to the N/S direction - this is GOOD !
But, they won't create a tornado because
there is no acceleration between the adjacent loops.
They have the same dimension.
There is no multiplication from one loop to another.
|
(fig : 5)
Notice, the loops are perpendicular to the N/S direction - this is GOOD !
These loop lines indicated on the card are NOT magnetic lines
of force, rather they are ELECTRIC lines of force.
These loops are set in MOTION
This motion manifests as CURRENT in the wire !
|
Figs : 4/5 indicates those loops of force produced around a current carrying wire. These electric loops are analogous to the Thought Loops of Mind. Mind Thinks electrically. When man creates polarity, his efforts are recorded in loops of electrical force to the measure of his efforts. These moving loops of electrical force simulate Mind Thinking that effort into physical existence.
As described, fig : 4 will manifest within the physical universe as 100% E-field, because all the loops are geometrically perpendicular to the N/S direction.
WR has taught us the importance of the 'division of gravity' and how that technique is used to bring dynamic motion of the a Creation Idea. 'Division of gravity' means that the motion about the central hub/shaft is not symmetrical. The motion thus wobbles as the orbit has more elliptical rather than circular character.
TIP :
If one were asked to wind an electrical coil to create a tornado one would almost always wind a coil as follows.
Natures tornado's are 100% E-field, they have NO magnetic component !
|
If you would but 'see' the tornado as a FIELD vortex rather than the geometry for the copper winding then you will understand the necessity to re-think how man should imitate Nature.
When Viktor Schauberger desired to create a vortex in the log plume he designed the structure to impart the correct motion TO THE WATER. Man fails in his attempts to harness Nature because he designs with his senses and applies the desired spiral motion to the windings and not the FIELD. The tornado above is a spinning FIELD.
|
(fig : 6)
Man runs his winding in an E/W direction, that
philosophy must change to run the windings in a N/S direction.
When the loops are aligned correctly there is
NO magnetic character evident (100% E-field)
|
(fig : 7)
Man applies spiral geometry to his WINDINGS when...
... he should construct coils to impart spiral geometry to the FIELD
When man's loop orientation fights that of Nature,
a B-field becomes evident.
|
Fig : 6 highlights the first major error of coil design almost every electrical engineer including Michael Faraday himself. That error pertains to the orientation of the electric loops of force and hence - CURRENT ! The red spiral lines of fig : 6 are NOT loops of wire rather they are the loops of force themselves. These loops have large central holes at the base, but very small central holes at the apex, The loops of force are therefore perpendicular to the N/S axis.
All too often the spiral geometry indicated in fig : 6 is believed to represent the windings of copper wire. This is a grave error !
Because of this simple misunderstanding, man has for hundreds of years orientated the current carrying wire at a tangent to that of the direction of the N/S division. Fig : 6 clearly shows (in red) where and how man's electric loops of force should be orientated.
Fig : 7 clarifies how when man adopts spiral geometry in winding his coils, the loops of force thus generated are not in alignment with the orientation required by Nature. Man should therefore realign his loops to parallel those of Mind Thinking. In short, Nature will always try to keep the E-field undivided to manifest 100% electric force. Man should copy this technique.
Fig : 7 (part a) indicates clearly that the spiral geometry are LOOPS of force and should not be confused with copper windings.
A cone base means a loop with a large central hole. An apex means a loops with a small central hole. The dimension of the central hole is directly proportional to the degree of concentrative Thinking applied to the condition. Weak concentrative Thinking manifests as the nebulous, cone base, cathode expression, while strong concentrative Thinking manifests as the compressed, apex, anode aspect.
To produce loops in the correct orientation as indicated in fig : 7 (a), the wire must be run N/S from the base to the apex !
It is the motion within the loops of force (the FIELD) which runs from S to N via E not the wire itself !
The loops generated by MAN due to his winding errors (fig : 7b) become what he believes to be is a separate force manifesting as the magnetic field, the B-field. The emergence of a B-field is a sign of imbalance. When the undivided E-field (fig : 6) is force to express itself as an E-field and a B-field component (fig : 7b), magnetism appears to emerge 90° from the E-field.
The emergence of such a 'magnetic' field is an indication of the imbalance, an indicator of man's imbalance with Nature.
But, this newly emerged B-field is electric and not magnetic. The magnetic experience arises from the 90° offset nature of the divided E-field.
We should reconfigure the loops which circulate around any live wire and realign those loops to be parallel to those indicating the N/S divide. The Cathode (open loop low current)/anode (closed loop very high current). In this way the losses to the magnetic field are recovered and the electric output is returned to 100% E-field. Remove the 90° offset between the magnetic/electric fields are align them both in the same direction. This will realign the wasted B-field and combine it with the original E-field (fig : 6) thus boosting (E-field x 2) the output as Nature would do it.
There is no B-field associated with this tornado motion, because the loops are aligned perpendicular to the N/S directional axis.
Marko Rodin has done some fantastic work developing toroidal coils as well as the vortex mathematical principles to accompany his theory. A typical coil of his design would look like,
whereby the coil windings follow a spiral geometry. It is my understanding that in order to produce WRC type centripetal/centrifugal motion of the field, it is necessary to impart this geometry to the field with the coils being aligned to produce this field geometry.
(fig : 8)
Running the current carrying wire from the cathode to anode follows more closely the tornado principle.
This conical model is completely in tune with the brook/reservoir model taught by WR, whereby meandering streams and brooks will accumulate potential/time if collected in a reservoir. The power of the cathode brook is low, while the power of the anode reservoir is mighty due to the accumulated time dimension.
Small thin wires are used towards the cathode base to simulate the many tiny streams feeding into the larger river/reservoir. As the coil is assembled towards the anode, the wires become fewer but thicker to facilitate the accumulated potential/current. This wire assembly will facilitate their loops of force to turn at 90° to the N/S axis exactly as Nature does it !
Those loops will therefore be contained within the conical shape indicated in fig : 8.
This will essentially realign the B-field and pull it back into alignment with Nature's E-field, so that both fields will run from cathode to anode. This effect alone will increase the voltage/current over conventional circuit designs.
| 
