WR’s Diagrams

The purpose of this page is to review some of WR technical drawings with the purpose of developing cohesive strategies for useful device design.

Fig : 1.1

Fig : 1.2

This drawing clearly indicates that the opposed apices interpenetrate one another in some way. What is the implication of this model ?
When WR lever/see-saw model is applied several features emerge. If we examine the lever model from a musical perspective we can assign the divided conditions as follows.

The seed condition of the inert gas may be described as a see-saw whereby the oscillation is minimal, almost zero. Both lever lengths are equal either side of a centering fulcrum. This inert gas condition is highlighted in Fig : 1.2.

Fig : 1.2a

In addition, we can assign this seed starting point as calm green with a musical frequency 364 Hz, an F#.
Because the lever lengths are equal and balanced if the balance was tipped to the vertical a symmetrical circular path would be traced as indicated in Fig : 1.2a

As the generative half of the cycle proceeds, the fulcrum not longer remains central. It must adjust to maintain balance between two unequal sides of the fulcrum. Potential and mass accumulate on one side of the fulcrum necessitating an adjustment to a shorter lever, while simultaneously the lever on the opposite side of the fulcrum extends to facilitate balance with the more nebulous expression. Small nebulous mass can balance very large mass if the lever is of the appropriate dimension.

Fig : 1.3 Yellow core – Cyan mantle
Fig : 1.3a Blue core – Orange mantle
Fig : 1.3b Red core – Violet mantle &
Fig : 1.3c Incandescent core – Black spacial mantle

Now, if the levers were allowed to oscillate through 180° we can see how the left side hemisphere is traced with ever decreasing radii, while simultaneously the right side trace hemispheres with ever increasing radii. The nett effect is indicated in Fig : 1.4.

Fig : 1.4

Fig : 1.5

These are not really two separate hemispheres, rather they are one spherical body, with a compressed and an expanded hemisphere, rather like when a balloon is squeezed.
Think of Fig : 1.4 as comprising half of a complete sphere, but it does so by providing half the core and half the surrounding mantle.
Now, there is an obvious positive projection to the left with its balancing negative projection to the right. Notice also, how the colour/frequency increases in stages towards the left as compression develops.
Likewise, colour/frequency decrease at each stage to maintain balance for each new position of the dividing fulcrum. Remember, division always creates two opposite conditions.
Those condition are not identical, but they are always balanced !
So, to create the full sphere again requires a union as follows.

Fig : 1.5 is the spherical representation of Fig : 1.1

This pendulum seems quite simple and straight forward, but within this simplicity lies all the complex perceived expression of our physical reality. So, a cursory glance will not suffice !

Fig : 2.1

Fig : 2.1a

Fig : 2.1b

Fig : 2.1c

Figs : 2.1 to 2.1c tell more or less the same story. They all contain a flaw which WR must have realised. At least the flaw is consistent. Maybe flaw is too strong a word but unless you are aware of the following issue you will find it difficult to determine how the other dimensions colour, frequency, heat/cold come in and out of existence.
It is such a pity because within these few simple drawings lies the ‘secret of the wave’ !
We know from MSS that as the pendulum swings there is an interchange between the potential and kinetic energies. At the center mid-point, the potential energy is minimum but the kinetic energy is maximum. At the full extent of the pendulum arc (2 locations) the potential energy is maximum while the kinetic energy is minimum. During the oscillation these two parameters continuously interchange.
I am sure WR had this in mind when putting pen to paper. The main issue with the images above lies with the length of the lever relative to the accumulation of potential during the oscillation cycle.

Fig : 2.2

The interval between the mid-point and one extremity is one octave as indicated here in Fig : 2.2. This is how the elephant and the ant can play see-saw. The lever must be adjusted as potential generates/radiates to maintain an overall balanced condition albeit an oscillating/dynamic balanced motion.
In order for the large expanded conebase condition to compress to an incandescent sphere it must pass through all the perceived colour range from 700 nm (black/red) to 400 (incandescent/violet) nm. Let’s stick with the conventional system for the moment. The colour sequence (octave) should then run from black, red, orange, yellow, green, cyan, blue/indigo, violet, to incandescent white.
We should not think of the Newton/Goethe colour wheel as a closed loop, because as we continue to compress past 400 nm into the uv/x-ray range we do not jump from 400 nm to 700 nm as a closed loop would suggest should happen.

We know the Mind is that Source of all physical expression. Omnipresent Source is located within the planes of zero curvature (PZC). The illusory reality appears to manifest ‘between’ PZC’s, but no such division can ever occur. Mind can never divide, it can only seem to divide.

WR teaches that Mind centers (hub center) all motion, AND that same Mind surrounds all motion (rim) from the outside. So, when a condition manifests close to Mind it is close to both rim and hub simultaneously. This might seem counter intuitive but is important so that our senses never gets a clear ‘image’ of what’s going on.
If they did, we could figure it all out through sensing alone !

#3

The explanation of these drawing given by WR can be somewhat misleading particularly when the concept of a ‘black hole’ is introduced. This terminology is then confused with the mathematical construct offered by MSS (Stephen Hawkins) as being somehow connected even describing the same gravitational phenomena. The key to unlocking WR meaning lies with Kepler.
Kepler discovered that the Earth moved around the Sun in an elliptical orbit with the Sun located at one of the two foci.
The Earth experiences the same forces at both foci, yet there is no gravitational body at one of those foci. The Sun is credited with all the gravitational force experienced by the Earth.

Imagine a body revolving in a perfectly circular orbit. All the radii from the hub center to the rim of the orbit are of equal length. In an ellipse, the radii are not of equal length because the hub center has moved away from the (0,0,0) focal center of the perfect circle and has thus distorted the circle to an ellipse. In 3D, we can think of the geometry as the shell surrounding a nut. The nut is no longer located at the dead center. The space it once occupied moves away in the opposite direction from the nut itself. This is how gravity is divided from a single focal point into two foci. Now, we know a wave form is a spiral loop, and a spiral loop is a series of open circular (closed) loops. In the image above both the positive anode body and the negative cathode ‘hole’ have moved away from the (0,0,0) focal hub of the perfect circle.
We also know that the Earth experiences acceleration as it approaches this ‘hole’ foci even though there is no ‘gravitational’ body present to pull on it !!!!!
Can you ‘see’ the ellipse within WR wave Fig : 65 from Atomic Suicide ?
What is more puzzling now is how/why the anode/cathode ‘hole’ is shown at the corners of the cubic wavefield in his Fig : 64 !

The positive anode has come into being as a result of a cold cathode compressing. This is what generation means, to generate a high potential from a low potential. This is akin to potential running uphill, an event which MSS does not recognise.
The cold negative ‘hole’ has come into manifest as a result of a hot anode expanding and radiating all its potential back to space. Whenever motion reaches its cathode destination it immediately wants to become a anode. Likewise, when an anode is created it immediately wants to shed all its potential and become a cathode. This is an endless cycle, the desire to be the opposite !
Think of the positive anode as the focal point for centripetal motion, while the cathode is the focal point from which centrifugal motion has emanated. When each pole reaches it maximum expression then they reverse. The anode now radiates to become a cathode and the cathode compresses to become the anode.
Motion running from the cathode to the anode is an uphill generative motion, while the motion running from the anode to the cathode is a downhill radiative motion.